3 jar Epilresin + 1 wax heater

Packaging: 3 x 500 ml jar. to be used in the wax heater + 1 wax heater +15 smeared wooden wax

Natural Product Made in Italy

Epilresin is a patented natural epilating resin, painless and antiallergic waxing for woman and suitable for any skin and for all types of hair can delay the regrowth of hair to over six weeks.

Painless waxing can be applied all over the body, including the perivaginal and perianal area; It does not require a pre-treatment or scrub since the resin itself acts as a skin scrub.

Not only will you have a smooth skin as you have never seen, but you can also say goodbye to annoying allergies and folliculitis.

In fact, the EPILRESIN resin avoids the following irritations: redness (due to tearing), folliculitis, ingrown hairs, double regrowth, prurito.Può also be used a few hours before sunbathing or make a solarium.

It does not need to be removed strips.

INCI Composition: Colophonium (Colophonium), Glyceryl Rosinate, Melaleuca alternifolia (tea tree), Lavandula angustifolia oil, Papain, Mentha Piperita Oil (Peppermint), Larrea divaricata Extract, Geranium robertianum Extract, Ananas Sativus Extract, Bromelain CI 61565.

INSTRUCTIONS FOR USE

Remove the plastic cap and pulling out the tab to remove the aroma preservation cap. Place the jar in the wax heater and set it to maximum power (100 degrees) until it begins to melt the resin at the edges of the jar.

With a wooden spatula to put pressure on a side of the resin so as to make it tip over and spill the resin dissolved in the surface. Lower the temperature to 36 degrees and mix the resin dissolved ensuring that both myeloma and verify the temperature otherwise wait for it to lower the temperature then apply the product evenly with a thickness of about 2 mm toward the direction of the hair.

Let cool a few seconds and then lift and pull gently against the grain.

If your hair is very short to apply the resin against the grain and remove always done counter.

The resin remaining in the jar can be used again following the same procedure.

Wax heater model Liberty in plastic to heat depilatory wax and resin in 500 ml jars. Temperature adjustment through the graduated thermostat up to 100 degrees with light indicating the achievement of the same.

Supply voltage: 230 Vac 50 Hz

Stove power: 150 W

cup capacity: 500 ml.

INSTRUCTIONS FOR USE

Place unit on a flat surface. Plug the power cord into the outlet and verify that the machine is warming up.

Place the jar containing the resin, 500 or 800 ml. inside the special cup.

For a rapid melting of the wax, place the thermostat (knob) to the maximum temperature, for about 15 minutes, then reposition the thermostat to the desired temperature, so as to maintain the fluidized product contained in the can.

The resin heating time can vary from 15 to 30 minutes.

The red light will go off whenever the desired temperature is reached.

MAINTENANCE OF THE PRODUCT

Cleaning the wax heater Liberty should be performed after wax with oil, alcohol or mild detergent.

E 'absolutely forbidden: the use of solvents and thinners, or partially or totally immerse the device in water or liquids in general.

The fine for greater conservation and appliance hygiene is always recommended to clean at the end use.